Inside the toilet water tank water to diffuse outside what reason be?

by:ANNWA SANITARYWARE     2020-08-26
Ceramic small make up tell you inside the toilet water tank water to diffuse outside there are several reasons, one; Pay attention to check whether water tank inside the water damage, 2; Check the water the water control valve is stuck, whether automatically rises after the expiration of the water. Three; Above water control rod are to prevent water overflow hole, is higher than that of the toilet water tank, the water control valve is higher than the water valve. Four; In < the tank below> gasket is damaged. 1) Fault phenomenon: no check section ( Power sockets, leakage protection plug, power button, the installation of the contact, the transformer for the first time, panel, PC board) Method: if there is a electric power socket? If yes, see the leakage protection plug reset button press the indicator lights do you have any show? Press the machine power? Cover and install a good contact? Is there a 7 v output transformer it? Water short circuit panel? If the above normal computer board. 2) Fault phenomenon: the water is not hot, Other normal) Check the parts ( Remote controls, radiator heating pipe, water temperature sensor, thermal fuse, the computer board) Excluded methods: remote control temperature set at room temperature? The wait for 10 minutes, no hot, please remove the measuring tank resistance is about 92 ohms around on both ends of the hotline, and test whether there are about 92 ohm resistor on both ends of the heating tube, without the fuse bad, measuring at the ends of the temperature sensor resistance ( 25 k ~ 80 k) Bad as normal, if all the computer board, such as in the tank, change detection is normal, after the water has been heated, PC board bad to change together. 3) Temperature is not heat (fault phenomenon: Other normal) Check the parts ( Remote controls, seat heater, temperature sensor, computer boards, connectors) Method: set up with the remote control heating state ( The wait for 10 minutes) Without heating, please remove the seat hotline measurement on both ends of the value of 960 + / - Around 50 ohms, without heating wire open, if you have any measurement on both ends of the temperature sensor resistance ( 5 k ~ 15 k) As normal, connector contact is good? If normal computer board. After such as change seat, change detection is normal, such as seat have been heating is computer board bad to change together
Custom message
暂无友情链接数据
Chat Online 编辑模式下无法使用
Chat Online inputting...